Applied-motion BLuDC4-Si Uživatelský manuál stáhnout pdf (Strana 7)

BLuDC-Si Hardware manualBLuDC-Si Hardware manual

BLuDC-Si Hardware manual

Connecting to the PC using RS-232

• Locate your computer within 8 feet of the BLU servo drive.

• Your drive was shipped with a communication cable. Plug the large end into the serial port of

your PC and the small end into the PC/MMI jack on your drive. Secure the cable to the PC with the

screws on the sides.

Never connect a BLU servo drive to a telephone circuit. It uses the same connec-

tors and cords as telephones and modems, but the voltages are not compatible.

If your PC does not have a serial port, you should purchase a “USB Serial Converter”. We have

had good results with the Port Authority “USB Serial DB9” Adapter from CablesToGo.com and with

the SW1301 from SewellDirect.com.

For laptops, a PCMCIA converter card is a good choice. Our applications engineers use the SSP-

100 from Sewell Direct.

Pin Assignments of the PC/MMI Port

(RJ11 connector)

ground (to PC ground)

TX (to PC RX)

No connection

RX (to PC TX)

1 2 3 4 5 6 7 8 9 10 11 12 ... 25 26

Žádné komentáře

Applied-motion BLuDC4-Si Uživatelský manuál Strana 7